Home » Produits » Commutateur audio »
Switch-ST is extremely easy to program using the display and the encoder on the front panel.
Switch-ST is equipped with a system of By-pass passive (Relay) able to « bypass » directly to the control circuit and switching, connecting the main entrance (MAIN) at the output (OUT) in the event of failure of the device extended or in case of power failure (unless this option Back-Up).
Switch-ST is equipped with an auxiliary output stereo, on RCA pin connectors to allow any connection to recording devices.
Switch-ST is able to accept external commands normally closed or normally open, inputs are optically isolated.
Switch-ST, trough the Logic I/O port, provides commands optocoupled output that repeat the status of the switches.
Techinical details
Inputs Stereo ( Main, Sub)
Analog audio input Electronically balanced
Input Impedance 10 KΩ
Common mode rejection Greater than 50 dB (30 Hz 15 KHz)
Connectors XLR Female
Output Stereo
Analog audio output Electronically balanced
Output level As Input level inTransparent Mode
Connectors XLR Male
LOGIC INPUT
Configuration Opto-coupled
(330 Ω protection internal)
Typical Voltage input 5 Vdc (for 10 mA input)
Max Reverse Voltage 5 Vdc
Connector DSUB 15 pole female
LOGIC OUTPUT
Configuration Optic solid state relay
Max Voltage 50 Vac/dc
Monitor Stereo Output
Output configuration Unbalanced
Output level As Input Level
Output Impedance 100 Ω
Connectors PIN RCA
USB serial interface Connector USB B
RS232 serial port DSUB 9 pole female
Connector DSUB 15 pole female
Stereo Separation degradation < 1 dB
Distortion @ 1 KHz < 0.01%
Signal to noise ratio < 85 dB (CCIR)
Max Current 100 mA
Power requirement 90 – 264 V ~ 50 – 60 Hz
Consumption 4 W
Power supply max power 8 W
Dimension (WxHxD) 48,3 x 19,4 x 4,4 cm
Weight 2,5 Kg. (5.5 Lbs)
Operating Temp. 0 ÷ 50° C
